KdFi Onboard Wideband Controller

Only the LSU4.2 is supoorted by the KdFi boards.

Activating the onboard widebandcontroller is done by jumper soldering or DIP-switching GP2 to GND and WBout to OXY1 & by cable loops on the PnP cable connectors.

  • Bosch LSU 4.2 BLACK
  • Bosch LSU 4.2 YELLOW
  • Bosch LSU 4.2 RED
  • Bosch LSU 4.2 GREY
  • Bosch LSU 4.2 WHITE
  • Bosch LSU 4.2 GREEN 

All cables/solderpads must be connected to have a working/error free lambda controller.


Green LED status(LD12):

  • ON: Lambda Controller is powered and standby
  • Flashing fast: LSU sensor heating up
  • Flashing slow: Lambda Controller normal operational

Red LED status(LD11):

  • ON: Error detected
  • Flashing: Error detected
Common Tunerstudio Settings:

  • Emulated Controller PLX
  • Signal 0-5V = AFR10-AFR20

Never ever leave LSU sensors electrically unconnected in the exhaust, thermoshock and condensation will kill sensors!
Only 1x LSU4.2 sensor can be connected to the onboard (any) wideband controller.


There are no products to list in this category.