KdFI Ignition outputs

Depending on the KdFi board, there are 1-2-3-4-6 or 12 High Power IGBT ignition outputs.

They are operated by the MS2 processor and ground operated.

  • Passive coils(dumb coils) can be directly connected to the KdFi, good grounds are required!

  • Smart coils(dis coils) can also be operated by the KdFi,however additional hardware or board mods are necessary depending on user requirements.

-Option 1: board adjustments IGBT removal and bridging IGBT pads (gate to source) 

-Option 2: additional pull-up board available in 2 versions.


These boards are a direct fit on the original basis KdFi boards an very easy to use and instal. 

The Motronic basis has all the needed pull-ups onboard and can be activated by an easy solder jumper.

Don't forget to adjust ignition settings within Tunerstudio!

There are no products to list in this category.