KdFi ECU
We have an extensive knowledge and expertise in the KdFI hardware and firm/soft-ware.
In case of errors or corrupted firmware we can reload the bootloader via the BDM.
Repairs and/or tests on component level is also possible in house!
Not sure which ECU to choose? See our KdFi ECU version help.
KDFI V1.4 Cinch enclosure
Read our FAQThe kdFi is a universal programmable Engine Management System for ignition and fuel inje..
399.00€ Ex Tax: 329.75€
KDFI V1.4 PNP
The kdFi V1.4 is mounted and wired in a stock housing and loaded with an initial startable base setu..
499.00€ Ex Tax: 412.40€
ECU Repair
ECU investigation and repair cost.Bootloader issuesResoldering componentsFirmware upgrades or issues..
13.92€ Ex Tax: 11.50€
ECU Wiring & Installation
Universal "Wire-in" a custom ECU wiring harness made specifically for your car. This option is ..
72.60€ Ex Tax: 60.00€
External Barometric Sensor
Barometric sensor for permanent altitude correctionNo connector included (are delivered with the KdF..
35.09€ Ex Tax: 29.00€
External Boost sensor high boost applications
Absolute Pressure Sensor for high boost applicationsNo connector included (are delivered with the Kd..
35.09€ Ex Tax: 29.00€
High Fun Map Sensor
Good for 4bar of boost, or for NA use in non-boosted applications.This board uses the easy to solder..
33.76€ Ex Tax: 27.90€
KDFI V1.4 Basis
Read our FAQBASIS VERSIONS IN BACKORDER TILL END OF JUNEThe kdFi is a universal programmable Engine ..
363.00€ Ex Tax: 300.00€
KDFI V1.4 Bluetooth Module Kperformance
This Bluetooth Module works with all kdFi V1.4.Just plug it between KdFi V1.4 Module and the lower P..
54.99€ Ex Tax: 45.45€
KDFI V1.4 IGBT ignition output
Remplacement 9V3040 IGBT ignition outputs.Please select appropriate type:Through-hole (Older Cinch K..
6.00€ Ex Tax: 4.96€
KDFI V1.4 Module
Read our FAQNEW UPDATED processor card!The kdFi is a universal programmable Engine Management System..
248.99€ Ex Tax: 205.78€
KDFI V1.4 Motronic DIY PCB Kperformance
A Universal KdFi Motronic DIY basis PCB. With this custom board you can now easily convert any 55pin..
162.09€ Ex Tax: 133.96€
KDFI V1.4 PNP Lambda Cable
PnP lambda cable for the KdFi V1.4 PNP units, suitable for LSU4.2 sensor.Available in different leng..
24.81€ Ex Tax: 20.50€
KDFI V1.4 PULL-UP add-on board
A complete add-on board for triggering Active coils.It solders straight on to the original KDFI igni..
6.41€ Ex Tax: 5.30€
KDFI V1.4 WIFI Module Kperformance
Word premiere plug&play WIFI module for the KdFi V1.4 This WIFI Module works with all kdFi ..
64.99€ Ex Tax: 53.71€
NoKnock PNP
Adaptiv module for knock detection with standard knocksensors direct plug in on all kdFi V1.4 P..
158.99€ Ex Tax: 131.40€
Rolling Road & tuning service on site
On site service.As a guide line;Cars in mechanical and electronic good conditions take 2-3hours to m..
90.75€ Ex Tax: 75.00€
KDFI V1.4 Original Basis PCB
BASIS VERSIONS IN BACKORDER TILL END OF JUNEOriginal base PCB board.Without processor module!..
95.59€ Ex Tax: 79.00€
KDFI V1.4 connector set
Connector set to connect the wiring loom with the KDFI ECU ..
24.99€ Ex Tax: 20.65€