NEW UPDATED processor card!

The kdFi V1.4 is mounted and wired in a stock housing and loaded with an initial startable setup.
 Please double check the correct unit/engine and/or installed wiring loom before ordering!

Remarques:
- Replace Throttle Switch with Throttle Position sensor/Potentiometer sensor If applicable (not included in delivery)

-AAA with wasted spark - please use ABV ECU

-M52TU units The following functions are not currently supported: Air conditioning, vehicle stability programs, no communication with automatic transmission, engine control lights up

Features:

• MS2 onboard / Firmware MS2extra
  
• Free Software / Open Source
  
• Fuel Table 16x16
  
• Ignition Table 12x12
  
• USB Connector
  
• Super accurate onboard wideband-lambda controller 
• Onboard MAP
• supports 12 coils
  
• supports low impedance injectors
  
• supports 2 and 3 pins Fast Idle Valves
  
• user programmable Relais outputs
  
• electronical boost control
• Launch control/ALS
• Flat shift
• Tacho output
• Table switching
• permanent Barometric correction prepared
  
• Rev input via: VR-Sensor, Hall-sensor
  
• supports CAN Bus